|
Carlon® Micro-Gard™ is
mini-duct that can be installed into empty or occupied duct structures
via jetting, blowing or pulling installation methods. Additionally,
very small cable, known as micro-cable, can be installed inside
the Micro-Gard product via the same methods.
Micro-Gard Mini-Ducts are similar to standard HDPE inner duct,
but manufactured using P3408 pressure resin rated at 3300 PSI to
resist relatively higher air pressures and pulling tensions on
these smaller ducts. The relatively smaller duct size creates potential
installation conditions that are more strenuous requiring higher
product performance characteristics in areas such as burst pressures,
minimum bending, pulling tensile and dimensional control that can
be more critical than with larger HDPE inner duct. Carlon has worked
extensively with other leading industry partners to develop a product
with performance characteristics to handle both jetting/blowing
and pulling environments. A full compliment of installation accessories
and fittings provides a complete system solution.
Key Features:
• 10 mm, 12 mm, and 16 mm sizes - provides application flexibility.
12 and 16 mm sizes are recommended for pulling or jetting; 10 mm
is recommended for jetting
•
Low sliding friction - aids in pulling and jetting of Micro-Gard
and micro-cables
•
High tensile strength material - allows for longer pulling distances;
reducing installation costs
•
Variety of colors/ stripes for identification - paralleling available
•
Sequential footage markings - determines distance of installation
and reduces waste
•
Pre-installed pull line optional (10 mm ID and larger) - allows
pulling of micro-cable
•
High burst pressure rated material - allows for jetting installation
and increases duct integrity for a high quality, low-cost installation
•
UV-formulated material - for outside storage conditions
•
Complete System of Duct, Couplings, Terminations, Pulling Eyes,
Pulling Harness and Cutters
Brochures:
Micro-Gard Specifications
Micro-Gard Price Sheet
Micro-Gard Quote Request
|